Site Forums »  General Forum » ProStar Boats         Display posts for: logout login  register register  search search  help help

post new topic
Subscribe This Forum Subscribe to this forum 
Topic Poster Post Views Last Updated
Showing results 1 - 20 of 242    Max Per Page
1 2 3 4 5 6 7 8 9 10 11 12 13  
Topic is Active - New Messages question Fiberglass on trailor busted
I was stupid enough to let someone drive only my trailer back to the house. This person didn't have a good idea of how to use the mirrors. Therefore, he pulled into the house and the trailer grazed the fence on one side. The fence is fine now but the fiberglass on my trailor is busted. I haven't tak... 		tim_burnham 5 299 Friday, August 20, 2010
05:55:19 PM
by: Tyler
Topic is Active - No Messages general barefooting
I'm a barefooter and was wondering if the 190 would have enough speed and strength with 400 hp. to tow me and maybe more. i weigh 150 lbs... 		slalom196 0 31 Wednesday, August 04, 2010
06:11:34 AM
by: slalom196
Topic is Active - New Messages general Wiring Diagram
Hi, I am having some issues with the gauges on my 2002 prostar 209. They are turning on and off, along with the radio, and the 12v acc plugs. I believe that I may have an issue with the accessory power from the ignition switch. Does anybody have a wiring diagram for the 2002 prostar 209 or similar?... 		larkin41 1 76 Friday, July 23, 2010
03:02:49 AM
by: servers9
Topic is Active - No Messages looking Need a starter
I'm in need of a starter for my 1994 ps 190 with the Indmar 350 motor. Does it matter if it's a marine grade or not? My local dealer told me to go to Napa or Baxters. If I need a marine grade, who has them?... 		lattitude24 0 19 Wednesday, July 21, 2010
11:30:14 PM
by: lattitude24
Topic is Active - No Messages looking O-rings for rudder
I'm trying to find the two O-rings that seal the rudder shaft.  I do not have Master Craft model with me (it's my brothers boat).  Water has been coming up through the hole in the hull where the rudder shaft inserts.   Does anyone know where I can purchase suitable O-rings? ... 		perkbobhope 0 40 Monday, June 07, 2010
08:23:23 PM
by: perkbobhope
Topic is Active - No Messages general Vibration in Steering Wheel
Replaced steering cable approx 18 months ago via local dealer. All good until last week. While boat loaded with teenagers and pulling kids on tube I began getting vibration in steering wheel at higher RPM's. Vibration only shows up when in gear as I checked in Neutral and no vibration. Could there b... 		gc9538 0 40 Wednesday, June 02, 2010
08:14:30 AM
by: gc9538
Topic is Active - No Messages help Perfect Pass Dash Display
The Perfect Pass on my 01 prostar is having issues with the down arrow button. It no longer works so my speed is stuck on the last highest one entered. Does anyone know if I can just replace the dash display to resolve the issues or could it be a wiring problem with the Master Module? ... 		u29460 0 31 Monday, May 24, 2010
09:09:51 AM
by: u29460
Topic is Active - No Messages general Performance Upgrades
Hello everyone, My 89' has a GM-454 with the original heads and intake. I've upgraded the ignition and rebuilt the carb already and the thing runs like a champ. Does anyone know who to contact for other performance upgrades? I was looking to put in an oil cooler for sure, but also curious on Intak... 		89BIGBLOCK 0 159 Sunday, October 11, 2009
07:46:06 AM
by: 89BIGBLOCK
Topic is Active - No Messages general Performance Upgrades
Sry double post..admin?... 		89BIGBLOCK 0 104 Sunday, October 11, 2009
07:44:43 AM
by: 89BIGBLOCK
Topic is Active - New Messages general Completely Restoring Fiberglass
Am I better off wet sanding the fiberglass or getting it repainted and re coated? Can I even do that? I have scratches from rubbing against the dock and some pretty good fading from 14 years of use. Funny how nice it looks wet though. What are the expert opinions? Id like to bring her back as... 		adwjr 4 337 Sunday, October 11, 2009
07:09:17 AM
by: 89BIGBLOCK
Topic is Active - No Messages general 99 ProStar 190 with LTR won't run at high altitude
I have a 1999 ProStar 190 with the LTR motor that has always ran great until this summer when I took it to a lake at 5500 ft and then to Lake Powell at about 3600 - 3700 ft. It was tough to get it started and keep it idling. After I got it running, it ran rough and very rich. I replaced the MAP sen... 		Mike ProStar 99 0 98 Monday, September 21, 2009
09:22:58 PM
by: Mike ProStar 99
Topic is Active - New Messages general How do I tell how many hours on my 190 Prostar?
Maybe a dumb question... Going to put my '91 Prostart 190 up for sale, but I don't know how many hours are on the boat. Most of the classifieds I see have the hours listed, did these boats come from the factory with hour meters? I don't think I have one, unless I'm missing it somewhere... Th... 		blueskies 2 164 Wednesday, September 02, 2009
10:44:45 AM
by: blueskies
Topic is Active - New Messages question low speed engine stall problem
I have a 2005 Prostar 205V with the Predator V-8 engine by Indmark.  It is the RPT-1, GM 350 cu in, 5.7L with EFI TBI.  Recently while "idle speed" cruising, the engine stalled or died.  The problem has repeated itself at other low speeds up to around 1500 rpms.  Aft... 		BobP 1 170 Monday, August 31, 2009
03:40:10 PM
by: BobP
Topic is Active - New Messages general How much ballast?
I am starting to look in to adding some ballast to my 209. I am going to start by puting in some sand bags in miscellansous placees around the boat. Ski locks, under front seets, under the back seet, etc. This will not be the permanent solution but it's cheap way to start experimenting before I star... 		bfrye 9 336 Wednesday, June 17, 2009
02:12:50 PM
by: kdub
Topic is Active - No Messages general gas springs for motor cover 2001 prostar 209
Can anyone out there tell me the lbs rating for the gas springs for the motor cover??? and while i'm at it , the rest of the gas springs as well since i will assume i'll be replacing all of them sooner or later.

SPD says it's proprietary information [mastercraft] ...you have to be kidding me

... 		rubypc 0 137 Wednesday, June 17, 2009
05:40:01 AM
by: rubypc
Topic is Active - No Messages question 94 prostar 190 no spray in throtle body to start
won't start .  I am geting spark, fuel to carb ,but no spray to start. Has anyone had this problem?... 		lancer 0 130 Monday, June 15, 2009
06:54:30 PM
by: lancer
Topic is Active - No Messages general 2003 prostar 197
The light cover on the bow light broke off into pieces.  The actual light is intact but the cover needs to be replaced.  What is the part number for the light cover?... 		sheridany 0 98 Sunday, June 14, 2009
11:04:46 AM
by: sheridany
Topic is Active - New Messages general Prop selection for 89 tristar 190
I have a 89 tristar 190, with 1:1 trans.  and a ford 351,  used only for skiing.  Does any one have a suggestion for a better prop?   Any experience with different props or pitches.  I would like better acceleration out of the h... 		matt a 1 218 Thursday, April 16, 2009
08:47:05 AM
by: mymc
Topic is Active - No Messages general Stock Alternator Amps ?
Need help ? what would be the amp rating in the stock alternator for my 1996 Prostar 190 w/ LT1 engine? Thanks for any help you can give me.
... 		Patrick Hardy 0 136 Tuesday, March 03, 2009
04:02:19 PM
by: Patrick Hardy
Topic is Active - New Messages general 1981 mastercraft prostar 190
i just bought this but i don't now what is the kind of the motor. the guys told me it's a ford 351 but if it's this it's a cleveland or a windsor and why the air filter it's write mercruiser. thanks... 		thevoices 1 246 Friday, February 27, 2009
10:19:50 AM
by: mymc
1 2 3 4 5 6 7 8 9 10 11 12 13

Whos Online?
There are currently 9 member(s).
Hop to:
guest you have limit capabilities as guest. Please login / register