|
||
|
| Site Forums » General Forum » MariStar Boats Display posts for: |
register
|
|
||||||||||||
|
||||||||||||
| Topic | Poster | Post | Views | Last Updated | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 2 3 4 5 6
|
||||||||||||
|
Engine and all electric just quit
We were cruising at 25MPH and the engine just quit and also all of the electric gauges and radio...nothing functioned. When we got to shore I noticed we had a large quantity of 'grass' wrapped around the prop and shaft. I removed all of the debris that may have contributed to the motor stopping.&nbs... |
brianob | 0 | 6 |
Saturday, September 04, 2010 10:37:37 PM by: brianob |
|||||||
|
fuel pump is not getting power
I have a 98 maristar 200V. I went to start it the other day and there was no fuel . The pump was not activating and the fuse is not blown, but there is no power to the pump.I'm not sure if It's the relay. I can't seem to get a reading with my meter from the relay either. I'm not sure what else to ch... |
dugzaster | 0 | 8 |
Monday, August 30, 2010 11:20:21 AM by: dugzaster |
|||||||
|
MMDC UNIT
Does anybody know where the MMDC unit is located?... |
Airchair | 0 | 10 |
Saturday, August 21, 2010 03:41:47 PM by: Airchair |
|||||||
|
Transmission fluid looks like Strawberry milk
I have a 1999 Mastercraft 230 VRS Maristar with the LT-1, and 630-V Hurth transmission. I bought it last fall and changed out all the fluids with synthetics. I've been running it quite a bit this season, and everything has been great. This past weekend I noticed that the tranny wasn't engaging rever... |
megapea | 1 | 55 |
Saturday, July 31, 2010 10:45:00 AM by: 6gun |
|||||||
|
Throttle Cable tension
How do you go about adjusting throttle cable tension on a 1996 Maristar 200RS? If you take hand off throttle above 2000 RPM in any remotely bumpy water, the throttle will go to idle. Not very smooth way of cruising!... |
rileywoof | 0 | 23 |
Friday, July 30, 2010 01:41:09 PM by: rileywoof |
|||||||
|
Reverse Polarity
I pulled a bone-head move when I replaced the battery on my 95 225VRS LT1 this year. I briefly hooked it up backwards (I know - what a dork). There was a pop and a puff of smoke that came off somewhere near the center of the engine near the top. I was surprised when the boat starte... |
Shredman | 1 | 59 |
Thursday, July 15, 2010 05:37:45 AM by: 6gun |
|||||||
|
Alarm at low rpm and battery goes dead
Problem #2 - I have a 2003 MariStar 210 with low hours. At low rpm, an alarm goes off. The only way to get it to stop is to kill the engine and restart. I think it may be a low voltage alarm because after a day's use, the battery will often be dead. I always have to carry a spare battery. Is th... |
aggievet_76 | 2 | 35 |
Thursday, July 15, 2010 05:13:40 AM by: 6gun |
|||||||
|
'07 Ballast Addition - 200VRS
Hi Guys, Wake surfing has turned out to be even more fun than I hoped. Now I need more ballast, and am sick of messing with the Tsunami pump. Anyone out there added a factory-type ballast system to their Maristar? Basically, I want to add pumps for the rear bags, one pump for each side, ... |
Thumbs | 2 | 156 |
Wednesday, July 14, 2010 06:25:04 PM by: Thumbs |
|||||||
|
Sulfur smell when using boat
I have a 2003 MariStar 210 with low hours (less than 300). When we are using the boat and it gets up to normal operational temperatures, it develops a bad sulfur smell. It does not smell like a hot engine and the engine temperature does not get above 160 according to the temp gauge. I can open th... |
aggievet_76 | 1 | 19 |
Wednesday, July 14, 2010 06:19:14 PM by: Thumbs |
|||||||
|
Ballast issue in 2001 v-drive
I have a 2001 Maristar V-drive with the front and rear ballast system. The water valves are located under the engine are controlled by hand knobs inside the starboard side rear hatch. They are connected to the valves under the engine by pushrods, similar to what you would find on a lawnmower. One... |
jchance | 0 | 35 |
Monday, June 07, 2010 09:47:21 AM by: jchance |
|||||||
|
Maristar Gauges
I am replacing the panels in the dash and was wondering if there should be any problems with hooking the gauges back up. Ive heard its difficult to get a car's gauges to work right if you disconnect them. Is this true and has anyone got any pointers on doing this. Thanks!... |
scog72 | 1 | 175 |
Monday, March 29, 2010 10:29:00 PM by: scramick11 |
|||||||
|
1997 Maristar V225 not 225 VRS
Hi all. I purchased my first Mastercraft this week. I bought a beautiful Maristar 225V with the LT1. I am trying to find more info on this boat but for some reason it is scarce. I would like to know the difference between a 225V and a 225 VRS? Thanks, Brent ... |
raleydog | 0 | 103 |
Sunday, March 07, 2010 01:01:16 AM by: raleydog |
|||||||
|
Winterize and changing fluids in 95 Maristar
I bought my 95 Maristar 200vrs a couple months ago and its time to winterize and change oils. I have the standard chevy 350 that came with the boat. The previous owner would run antifreeze through the engine and not drain anything when he would winterize it. I would like to do the ... |
jax-200vrs- | 0 | 132 |
Friday, October 23, 2009 03:07:05 PM by: jax-200vrs- |
|||||||
|
Winter storage of my MariStar
I recently purchased a 1999 MariStar 230VRS with a Corvette LT-1 motor. I am going to winterize the boat myself and have read NOT to use RV antifreeze, just drain the block. Is that still the prefered method of thinking? If so, should I try to blow out the block with compressed air? If so, how do I ... |
megapea | 1 | 228 |
Thursday, September 17, 2009 06:33:46 AM by: vkazmer |
|||||||
|
1995 Maristar Bilge Pump
My bilge pump is not operating. The current pump has a replacable cartridge pump and I have installed a new pump. The pump did not operate so I checked for power in the wires leading to the pump - there was no power. So working backwards from the pump, I suspect that the rocker switch for the bilge ... |
vkazmer | 0 | 106 |
Thursday, August 13, 2009 08:34:54 AM by: vkazmer |
|||||||
|
1997 Maristar Swim Platform-Bow Cushion
Has anyone replaced the rubber material on the molded swim platform, I am looking for a good solution? Also, is the fill in bow cushion available anywhere? Thanks.......new to the sight. Do all my own maintainence and will be glad to offer any help I can. Thanks..........Rich... |
California Dreamin | 3 | 241 |
Wednesday, August 05, 2009 01:42:40 AM by: California Dreamin |
|||||||
|
Maristar wakeboard towers
Can anyone tell me what my options are for towers on a 1999 Maristar 230 VRS. I hate to sound vain, but looks are important. ... |
mjwoody2 | 1 | 216 |
Friday, July 31, 2009 05:03:14 PM by: randykyra |
|||||||
|
02 X10 gauges intermittant
My gauges turn on like normal, but after less than a minute they all turn off (everything except perfect pass, I assume that is wired seperately). I searched and found something about a possible ground issue, but I couldn't load the link that was posted to see if it was the same issue I was hav... |
BillWalmer | 0 | 113 |
Monday, July 20, 2009 11:36:02 AM by: BillWalmer |
|||||||
|
05 X45 won't run
I have an 05 X45 6.0 cady motor. It was running great. I shut it down to switch riders, then nothing. It would crank but no fire. It sounds like the fuel pump runs and primes. Can anyone tell me if the fuel filter is in the tank? If so is it something I could change out? Thanks for any input Sam... |
egit | 2 | 150 |
Thursday, July 09, 2009 07:24:26 AM by: egit |
|||||||
|
Maristar 210VRS Transmission Leak
I have a 1998 Maristar and noticed the bilge was full of transmission oil...yep, it looked like strawberry milkshake....I have a friend who is a great boat mechanic, he has done many v-drives on bigger boats but never on a Mastercraft....he noticed that the tranny is real close to the gas tank on my... |
copout | 3 | 686 |
Wednesday, July 08, 2009 12:16:50 PM by: DW |
|||||||
1 2 3 4 5 6
|
||||||||||||
|
Whos Online? There are currently 10 member(s). |
|
guest you have limit capabilities as guest. Please login / register |